Half Sphere Mould And Cutter Set (Various Sizes Available)

Description

This listing is for an item(s) that is printed with PLA filament using a 3D printer.  The photos alongside the main photo will show you bisque fired earthenware clay pieces made with the cutters / stamps and also some painted pieces for inspiration.  You will also find extra inspiration in our gallery.

This item is perfect for making your own bisque to sell in your PYOP studio, for use within a pottery studio, or for your own handicrafts…. the only limit is your imagination!

The colour of your cutters and stamps may vary from those shown in the photograph.

After use, rinse in cool water (never use hot water and do not soak) and dry immediately.  Store in a cool, dry place.

Instructions to make a half sphere…

1. Roll out clay to 7mm thick – it’s best to use slightly firmer clay so that it holds its shape easier
2. Powder the dome former with talc or corn flour
3. Brush the clay with talc or corn flour so it doesn’t stick to the dome
4. Drape the clay over the dome mould and firm the clay around
5. Press the cutter down over the mould and cut away any excess clay
6. Turn over the dome and cutter and lift the cutter off
7. Tidy up the edges and give the dome a little twist to release the clay then lift out the mould
8. Decorate your half sphere however you want. Add clay or cut bits away. Just remember to score and slip and clay that you add

Instructions to make a full sphere…

1. Repeat the previous steps to make a second half sphere
2. If you want to cut a hole in the sphere to add lights then choose one side to be the bottom of the sphere and pop it back onto the former. Cut out a hole large enough to fit any lights later. If you don’t to add a large hole for lights, just poke a small air hole in one side
3. Let both sides firm up a bit before attaching the two sides together
4. Score and slip the edges of both half spheres
5. Place your two pieces together and use your finger or a clay tool to blend the seam where they join on the inside and outside of the sphere (add small bits of clay or slip on the inside if needed)
6. Decorate your sphere however you’d like by adding decorations or cutting bits away. Just remember to score and slip anything you add