Dippy Egg Workshop Set

Description

This listing is for an item(s) that is printed with PLA filament using a 3D printer.  The photos alongside the main photo will show you bisque fired earthenware clay pieces made with the cutters / stamps and also some painted pieces for inspiration.  You will also find extra inspiration in our gallery.

This item is perfect for making your own bisque to sell in your PYOP studio, for use within a pottery studio, or for your own handicrafts…. the only limit is your imagination!

The colour of your cutters and stamps may vary from those shown in the photograph.

After use, rinse in cool water (never use hot water and do not soak) and dry immediately.  Store in a cool, dry place.

Instructions to make a dippy egg plate…

1. Roll out clay to 7mm thick
2. Dust the plate cutter with talc or cornflour then cut out the plate
3. Roll a ball of clay, about the size of a satsuma
4. Pinch out the ball of clay into a little pot – check the size with an egg, remembering to allow for shrinkage during drying
5. Tap the base of the pot on the table to give a flat base
6. Score and slip the base of the pot and an area on the plate where the pot will be attached
7. Firm the egg pot in place
8. Use the alphabet stamps to stamp in the wording of your choice
9. Leave to dry completely before firing